Shutter actuator JA3-02B/DC
- For controlling drivers of shutters, blinds and awnings with power supply 24 V DC
- JA3-02B/DC actuator serves to control blinds, shutters, garage doors, entrance gates, etc.
- Operates electrical motors, which are controlled in 2 directions and have a built-in limit switch.
- JA3-02B/DC controlled electric drives with supply voltages up to 24 V DC, where the direction of rotation of the driver is controlled by changing the voltage polarity of the motor.
- The unit is equipped with thermal and overcurrent overload protection outputs.
Status of units is indicated by green LED RUN on the front panel:
- with the supply voltage connected (through BUS) and the unit is not controlled by bus BUS, LED RUN shines.
- with the supply voltage connected (through BUS) and the unit is controlled by bus BUS, LED RUN flashes
Status of output contacts UP/DOWN:
- JA3-018M is an actuator designed to control roller shutters, blinds, awnings, garage doors, entrance gates.
- Controls electric motors that operate in two directions and have a built-in limit switch.
The status of the unit is indicated by the green RUN LED on the front panel:
- If the power supply is connected, but there is no communication via BUS with the master, the RUN LED is continuously on.
- If the supply voltage is connected and the unit communicates by BUS, the RUN LED flashes.
The status of the output contacts is indicated by the U / D LED:
- Output: 9x switch 4 A / AC15.
- • Voltage 250 V AC, 24 V DC.
- • JA3-018M in 6-MODUL version is designed for DIN rail installation EN60715.
- • Dimensions: 90 x 105 x 65 mm.